Billet what?


On 18 February 2014 17:24, Looonie <supras@boost.org.nz> wrote:
Facelift JZA80 ones are fairly reasonably priced through Mark @ Manawatu Toyota.

Otherwise, do what I did in the Z20 and get a roughly 2" rod of billet cut down to two lengths of 80mm, drill a hole through each one, two bits of high tensile threaded rod, flat washers, spring washers and nyloc nuts... voila!

Che che
Looonie

-----Original Message-----
From: bounce-102191-4880@list.supras.org.nz [mailto:bounce-102191-4880@list.supras.org.nz] On Behalf Of axel jones
Sent: Tuesday, 18 February 2014 8:55 a.m.
To: Supra Club of NZ Mailing List
Subject: [sconz] jza70 engine mounts

anyone know where i can get some aftermarket engine mounts?
need something heavy duty, (been using mount shop ones but rh one always breaks ! ) ideas?

---
Supra Club of New Zealand - http://www.supras.org.nz/ Website sponsored by Alltech Diesel & Turbocharger http://www.turbo.co.nz



---
Supra Club of New Zealand - http://www.supras.org.nz/
Website sponsored by Alltech Diesel & Turbocharger http://www.turbo.co.nz