Hi Hunt,
Its all questions :)

Is your diff a g299/319 torsen?
What did you diagnose as the problem?   What is the condition of your ring and pinion?  Was their any backlash or preload issues?

Regards,
Marc

On 25 Feb 2014 19:29, "Hunt M" <huntatwork@gmail.com> wrote:
>
> I haven't done mine yet. I've taken it apart and have all 4 bearings. But need to grind the old rear pinion bearing off as I can't find a puller that fits. Possibly the same for the 2 side ones dammit.....
>
>
>
>
> On 25 February 2014 19:25, Marc Archbold <marc.archbold@gmail.com> wrote:
>>
>> Hi Suzy,
>> Not yet.  Although it appears Hunt may have .
>>
>> I neee to remove it and temporarily fit the 3.9 Torsen I have and take a look.  From net research, bearings are the culprit but need to dismantle to be sure.
>>
>> Cheers,
>> Marc
>>
>> On 25 Feb 2014 18:47, "Suzy W" <suprra@gmail.com> wrote:
>> >
>> > dammit dammit dammit
>> >
>> > Marc did you do your diff yet?
>> >
>> >
>> > On Fri, Feb 14, 2014 at 12:14 AM, Suzy W <suprra@gmail.com> wrote:
>> >>
>> >> Ahh so translating not required then :) All good, it's a long term project anyway as the tsrm for the jza70 is very large and is in 2 parts lol. Just doing the electrical wiring diagrams for the short term xD
>> >>
>> >>
>> >> On Thu, Feb 13, 2014 at 9:00 PM, Marc Archbold <marc.archbold@gmail.com> wrote:
>> >>>
>> >>> Hey that's great of you Suze, many thanks!
>> >>>
>> >>> Have compared against the MA70 TSRM and apart from a couple of sequence differences, can confirm that specs are the same as the MA70 TSRM 8".
>> >>>
>> >>> Now on to servicing.
>> >>>
>> >>> Cheers!
>>
>> ---
>> Supra Club of New Zealand - http://www.supras.org.nz/
>> Website sponsored by Alltech Diesel & Turbocharger http://www.turbo.co.nz
>
>
> ---
> Supra Club of New Zealand - http://www.supras.org.nz/
> Website sponsored by Alltech Diesel & Turbocharger http://www.turbo.co.nz